-
product
Solid State Flasher, DC Input
A738
NAI’s A738 is a 2.5 A, DC Input, Aircraft Warning or Position Light Flasher. This solid-state, single-channel unit is designed for airborne use and performs to all applicable military specifications.
-
product
5A Solid State Flasher, DC Input
A915
NAI’s A915 is a 5 A, DC Input, Aircraft Warning or Position Light Flasher. This solid-state, single channel unit is designed for airborne use and performs to all applicable military specifications.
-
product
4A Solid State Flasher, AC Input
A915-8
NAI’s A915-8 is a 4 A, AC Input, Aircraft Warning or Navigation Light Flasher. With low RFI/EMI, zero crossover switching employed in the output circuits, this solid state, single channel unit provides long device and load life.
-
product
Digital Total Dissolved Solids Pen (TDS)
CD600
The Milwaukee CD600 Total Dissolved Solids (TDS) Pen is designed for hydroponics, aquariums, horticulture, water conditioning and many other applications. The CD600 helps you make sure that your plants are receiving the right amount of nutrient or helps you keep your filters up-to-date and clean for water filtration. Keep TDS in your target range to help your achieve better results.
-
product
Dissolved Oxygen Instrument
550A
The 550A dissolved oxygen instrument has been discontinued. YSI will continue to support existing 550A's through 2020. We recommend the Pro20i as a direct replacement. The Pro20 and ProODO handheld instruments are also suitable replacements. See the Pro Series Guide for discontinued YSI handheld instruments and their replacements.
-
product
Dissolved Oxygen meter
CyberScan DO 110
The CyberScan DO 110 Dissolved Oxygen meter is an improvement of the DO 100 with RS232 output to printer, an increased memory log to 100 data sets, extended battery life to more than 700 hours, wider barometric pressure correction range of 500 to 1499 mmHg, 2-point calibration and Fahrenheit (°F) display.
-
product
Dissolved Oxygen
Is designed for the continuous measurement of trace levels of dissolved oxygen in aqueous systems.
-
product
Dissolved Ozone Instruments
Teledyne Advanced Pollution Instrumentation
For measuring dissolved ozone concentrations in water a microprocessor controlled instrument can be used for automatic and continuous measurement by means of an disinfectant sensor. All of our instruments are designed meet the rigorous demands of ambient air quality, stack, or industrial process gas monitoring.
-
-
product
Dissolved Ozone Analyzer
Model 470
Teledyne Advanced Pollution Instrumentation
The Model 470 is a state-of-the-art Dissolved Ozone Sensor designed for semiconductor Wet Bench tools and many other industrial processes. It provides continuous measurement of dissolved ozone in deionized water or sulfuric baths with concentrations up to 150 mg/L. The Model 470 is “clean-ready” for high purity semiconductor processes, and is designed to be simply spliced in-line in the recirculation loop of any wet bench tool with flow rates up to 150 SLPM.
-
product
PRO High Range Total Dissolved Solids Meter
MW402
MW402 is a Portable Conductivity High Range (TDS) Meter with Automatic Temperature Compensation. This instrument has been designed for aquariums, aquaculture, labs, and water conditioning applications to meet the needs for equipment suited from hobbist to professional. It is also a great meter for food labs, and water treatment applications.
-
product
Solid State Drives
Curtiss-Wright Defense Solutions
SSDs are removable mass storage devices used in data recorders. They provide rugged storage of data. The SSD is easily removable and can be connected to a PC (via a GTS/BAY/001 or similar device). The SSD uses an eSATAp connector when connected to a PC. When inserted in an some network recorders, it automatically switches to the recorder's internal connector.
-
product
Waterproof Conductivity Dissolved Oxygen Meter
CyberScan CD 650
Equipped with the sophistication of laboratory meters, Eutech’s CyberScan CD650 allows the simultaneous measurement and display of conductivity and dissolved oxygen. Intuitive with built-in guidance prompts and trouble-shooting tips, the meter comes with advanced wireless communications technology for easy meter-to-PC data transfer, and is IP67 waterproof for harsh applications.
-
product
Optical Dissolved Oxygen Sensor
Model 423/C/OPT
Low-maintenance D.O. for Aeration Control in Wastewater Treatment
-
product
Solid State Contactors
Mitsubishi Electric Automation, Inc
With virtually an unlimited life cycle, Mitsubishi Electric solid state contactors provide clean and silent operation in applications such as temperature controllers and lighting systems that require reliable power control at low noise levels.
-
-
product
Solid Density Analyzers
The solid density analyzers from Anton Paar are tried and tested solutions. The Autotap and Dual Autotap tapped density analyzers conform to a wide range of international standards for the determination of bulk density. The Ultrapyc automatic gas pycnometers are ultra-simple to use and provide ultra-precise skeletal density or true density measurements of your solid materials. The Micro Rotary Riffler ensures representative sampling of the samples typically used for particle size, mercury intrusion, and gas sorption experiments from the larger amounts delivered to your lab.
-
product
PRO Total Dissolved solids (TDS) Monitor
MC410
The Milwaukee MC410 PRO Total Dissolved Solids (TDS) monitor lets you measure TDS levels automatically and alerts with an alarm when out of the set point range.
-
product
Solid State Voltage Injector
J2110A
While it is possible to obtain high quality injection transformers with bandwidths as wide as 1Hz to 5MHz or more, in some cases this is still insufficient for some tests. For example a typical heater control loop might have a bandwidth of less than 1Hz while some linear regulators and opamp circuits can have bandwidths of up to 100MHz or in some cases even higher. For these applications, a solid state injector can provide the necessary bandwidth. A solid state injector can perform at DC, while the upper frequency limit is dictated by the components selected and the printed circuit board material and layout. It is possible to obtain a solid state injector with a working range of DC – 200MHz, though above 50MHz the interconnection between the injector and the circuit being tested can become quite critical. It is essential that ripple from the injector power supply does not dramatically degrade the dynamic range or the signal to noise ratio of the measurement. The resulting plots are often much cleaner when using a solid state injector than with a transformer injector.
-
product
Solid Measuring Viewer
SMV system is designed to perform automatic final inspecting system. SMV integrates professional vision and optics technology. Besides, reliable mechanical system reduces the maintenance time. It is especially suitable for the demand for high quality and low cost inspection. Unique inspection techniques adapt to all 3D measuring. It can detect laser Via, dimple, bump, copper plating thickness, line, SMT, BGA, etc. SMV provides 3D image and 3D measuring result. SMV adopts programmable LED lighting to obtain the best image.
-
product
Dissolved Oxygen Concentration Monitor Series for Semiconductor Manufacturing
HD-960LR
Ideal for measuring dissolved oxygen concentration in Wet Process from Front-end of Line to Back-end of Line.By adopting a chemical resistant sensor, it is possible to support a wide range of dissolved oxygen concentration measurements from facility to process usage.
-
product
Waterproof High Range Total Dissolved Solids Pen (TDS)
T76
The Milwaukee T76 Waterproof High Range Total Dissolved Solids (TDS) Pen is designed for, aquariums, aquaculture, education, pools, water conditioning and many other applications. The T76 helps you make sure that your fish have the right TDS balance to help them stay healthy. TDS also help keep filters up-to-date and clean for water filtration or pools. Keep TDS in your target range to help your achieve better results.
-
product
PRO Dissolved Oxygen Meter
MW600
The Milwaukee MW600 PRO Portable Dissolved Oxygen meter is one of Milwaukee's most popular meters with its reliable and fast operation as well as its accuracy.
-
product
28.00 (711.20) 19" Solid Panel
P-2819
Special grade .125” sheet aluminum (5052-H32 EPS). Each side, edge and corner is carefully de-burred and chamfered to provide a flawless finish, resulting in a superior quality panel. Finish is textured unless otherwise specified.
-
product
8.75 (222.25) 19" Solid Panel
P-0819
Special grade .125” sheet aluminum (5052-H32 EPS). Each side, edge and corner is carefully de-burred and chamfered to provide a flawless finish, resulting in a superior quality panel. Finish is textured unless otherwise specified.
-
product
Solid State Gas Detectors
SMC 20X/200X
The SMC 20X/200X are single-gas detectors used to monitor combustible gas, hydrogen sulfide (H2S) or carbon monoxide (CO). The detectors are based on solid-state technology, a simple and robust method of detection capable of detecting low parts-per-million (ppm) levels of gas.
-
product
Bluetooth® Enabled Dissolved Oxygen (DO) & Temperature Pen
UltrapenX2™ PTBT5
*Industry Leading Accuracy*Display DO in Concentration, % Saturation, or Both*Adjustable for Altitude and Salinity*3 Calibration Methods: Air, Water and 0 ppm DO*Dynamic Membrane Temperature Correction*Measurement Storage with Time, Date and Location*Export Stored Measurement Data Via Email*Live or Hold Mode – User Selectable*Proprietary Sensor Design*Rugged Design with Aircraft Aluminum Body*Durable, Epoxy Encapsulated ElectronicsWaterproofPowered by One N Type Battery (Included)
-
product
Solid Tungsten Probe Tips
ST Series
The ST SERIESof probe tips, available from GGB Industries, Inc., are precision crafted from a 0.020 inch (0.51mm) diameter solid tungsten shaft that is electrochemically sharpened to a specified point. These durable, 1.5 inch long solid tungsten shaft probe tips are for use in most standard micropositioners when probing an integrated circuit, pad, or line. A variety of radius point sizes from 0.5 microns to 10 microns are available to accommodate any probing need.
-
product
19.25 (488.95) 19" Solid Panel
P-1919
Special grade .125” sheet aluminum (5052-H32 EPS). Each side, edge and corner is carefully de-burred and chamfered to provide a flawless finish, resulting in a superior quality panel. Finish is textured unless otherwise specified.
-
product
21.00 (533.40) 24" Solid Panel
P-2124
Special grade .125” sheet aluminum (5052-H32 EPS). Each side, edge and corner is carefully de-burred and chamfered to provide a flawless finish, resulting in a superior quality panel. Finish is textured unless otherwise specified.
